According to the special importance of hospitals, it is highly recommended to install a network clock system in the corridors, nursing station, toll booths and lounges of hospitals, so as to provide a standard time display system for patients and doctors.

The clock of the network clock in the hospital is also the NTP clock server. Besides providing standard time source, it also needs to provide a unified time reference to all computers in the local area network of the whole network, such as the network clock system.

NTP clock server networking can also provide standard time information for monitoring system, medical equipment, doctor office computer network, network clock system and so on.

Network clock is an intuitive display, used to display the current time information, in a system can clearly show the current need to see the time information, mainly installed in the hospital corridors, operation room, toll booth, lounge, nursing station and other places. Generally choose the sub clock of network communication, transmit information through the network cable, and there is a network port on the sub clock to communicate.

Network clock installation

Before installing, Zi Zhong needs to bury the hook, power cord and wire line on the reservation points.

The ceiling of the bell can choose stainless steel suspender, highlighting its modern style. The power line and the cable can be hidden in the casing, and the LED luminous module which is consistent with the background atmosphere is selected according to the different installation areas.

Single face clock installation generally chooses wall hanging.

Most of the single face clocks are installed in wall mounted mode, and can also be suspended according to the actual situation. According to the different installation areas, the LED luminous module which is consistent with the background atmosphere is selected. The signal and power supply interface is connected by the rear opening, and the outside has no exposed lines.

Installation specification

NTP time server is usually installed in the computer room, installed on the cabinet, connecting core switches.

Clock, the hall and general corridor installation height is 3-4 meters, the doctor office installation height is 2.3 meters, operation room generally about 1.5 meters, eyes can be seen clearly, other public areas installation height is usually 3 meters, because the interlayer is short, need to close the ceiling installation.

In order to reduce interference, there is at least 1M interval between the wires, between the power supply and the signal.

The power supply mode is supplied by 220V power supply for nearby power supply.

The time source of the NTP receiving server is connected to the router through the network. The signal interface from the router is connected with the sub clock, and the sub clock is connected by hand to hand mode.

The copyright of this article belongs to Xi'an in all respects, respecting originality, strictly prohibit manuscript, unauthorized, no reprint, copyright, infringement must be investigated!