The following are detailed steps for configuring NTP customers in common Windows systems, including how to organize policies, modify NTP server IP addresses, and modify time to time intervals.

One , Open "start" and click Run input. Gpedit.msc, And then "confirm".

Two , Enter the following interface, click the management template under the computer configuration.

Three , Enter the following interface and double-click the system to see the following options

Four , Double click " Windows Time service, then double-click "time provider".

Five , Double click "start" Windows NTP Client, then select "enable" option, click Next settings.

Six , Configure the settings option as shown below, time.syn029.com It was opened by our company. NTP Time server address

Seven , Then you can make sure that you can double-click the lower right corner of the desktop. And then choose

" Internet Time "option

Eight , As follows, click "apply" and choose "update immediately". You will get accurate results without any problems. GPS Time, If the connection is timeout after updating, try several times, and the initial synchronization is slow.

Nine , If prompted RPC The server is not available, and is input in "start" - "run". Ervices.msc Then find Remote Procedure Call (RPC) and Remote Procedure Call (RPC) Locator Option double click and modify to start. Type is automatic, then restart the computer. OK 了

Ten The setting of synchronous frequency can be set in the "start" and "run" by setting the following settings.Regedit , modify HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\W32Time\TimeProviders\NtpClienT\SpecialPollInterval, the value is decimal 900 (double click SpecialPollInterval can be modified).

The above is the commonly used NTP client configuration, and the other NTP client configuration will continue to update. Welcome to pay attention to the Xi'an synchronization public address.